5219 E 24TH AVE , ANCHORAGE AK 99508
The most recent inspection (follow-up) found no violations at all. The prior opening inspection flagged only equipment/setup issues (missing sanitizer test kit, low hot water pressure at the mop sink and dish machine) that were administrative or facility start-up problems, not evidence of contaminated or improperly held food, and these were resolved by the follow-up visit.
No violations noted.
A test kit or other device that accurately measures the concentration of sanitizing solutions shall be provided. AMC 16.60.150(4-302.14) **A TEST KIT OR OTHER DEVICE WAS NOT PRESENT DURING THIS INSPECTION TO TEST THE INTENDED SANITIZING SOLUTION. PERMIT HOLDER STATED THEY INTEND TO USE CHLORINE-BASED SANITIZING SOLUTION. PERMIT HOLDER MUST OBTAIN A TEST KIT OR OTHER DEVICE INTENDED TO TEST THE CONCENTRATION OF SANITIZING SOLUTION BEING USED. IF PERMIT HOLDER CHOOSES TO USE A CHLORINE-BASED CHEMICAL SANITIZER, THE TEST KIT OR OTHER DEVICE MUST BE INTENDED FOR CHLORINE-BASED CHEMICAL SANITIZERS. FOLLOW DIRECTIVE ABOVE.
The water source and system shall be of sufficient capacity to meet the peak water demands of the food establishment. AMC 16.60.160(5-103.11.A) **THE PLUMBING SYSTEM HAD SUFFICIENT HOT WATER TO ALL FIXTURES EXCEPT THE MOP SINK AND THEN MECHANICAL WAREWASH MACHINE. WHEN THIS INSPECTOR TEST THE MOP SINK, THE COLD WATER HAD ADEQUATE PRESSURE; THE HOT WATER DID NOT HAVE ADEQUATE PRESSURE AND WAS COLD TO THE TOUCH. PERMIT HOLDER MUST MAKE THE NECESSARY CORRECTIONS TO THE MOP SINK TO ENSURE THE HOT WATER HAS ADEQUATE PRESSURE AND TEMPERATURE. THE MECHANICAL WAREWASHING MACHINE WAS NOT ABLE TO OPERATE AS THERE WAS AN ERROR CODE ON THE MACHINE THAT INDICATED THE WATER PRESSURE AND/ OR TEMPERATURE OF THE PLUMBING SYSTEM CONNECTION MAY NOT BE WORKING CORRECTLY, THUS ACTIVATING THE SAFETY FEATURE OF THE WAREWASHING MACHINE THAT DOES NOT ALLOW THE MACHINE TO OPERATE WITHOUT ADEQUATE WATER PRESSURE AND/TEMPERATURE. PERMIT HOLDER STATED THEY WILL MAKE THE REPAIRS TO THE SYSTEM TO ENSURE THE MECHANICAL WAREWASHING MACHINE HAS ADEQUATE WATER PRESSURE AND TEMPERATURE. PERMIT HOLDER MUST FOLLOW DIRECTIVE ABOVE.